Page 3 of 3

Re: My KR1s Project

Posted: Fri Feb 12, 2016 7:19 am
by Ian_B
Your bike looks fantastic, great job!

Re: My KR1s Project

Posted: Fri Feb 12, 2016 8:58 am
by Top-shaggy
It's a smasher ..great rebuild mate :)

Re: My KR1s Project

Posted: Fri Feb 12, 2016 10:06 am
by SP_BOTT
That is stunning, hope to finish my paintwork this year (again), also reminded me to get an exhaust bracket too, have fun with it. :)

Re: My KR1s Project

Posted: Fri Feb 12, 2016 5:59 pm
by pookie
Very nice, If you want the exhausts to match the rest of the bike you can get them ceramic coated, i've had this done to the 4-1 system on my 250cc katana, when I had it done I asked the boss of the company (performance 1 coatings) if they can coat two stroke expansion chambers and he said yes, its an amazing transformation, a really tough, durable finish that also keeps the pipes running cooler :)

Re: My KR1s Project

Posted: Thu Feb 18, 2016 11:58 am
by Llewe
Excellent work there mate, one of the best around, my own rebuild is almost finished and I will post pictures shortly, but I have to say it's not as good as yours. What Pookie says about ceramic coating the exhausts sounds good and I am going to look into that.

Mark.

Re: My KR1s Project

Posted: Thu Feb 18, 2016 12:13 pm
by Llewe
Hi Toby
Just wondering how you applied the decals, I done OK with mine apart from the yellow number board which I had air bubbles under and could not rectify, ended up tearing it off. I used the wet type application method, the decals I used are from the same place as yours (Andy at classic reproduction decals) which are good.

Any thoughts?
Mark

Re: My KR1s Project

Posted: Thu Feb 18, 2016 9:39 pm
by toby69
Llewe wrote:Hi Toby
Just wondering how you applied the decals, I done OK with mine apart from the yellow number board which I had air bubbles under and could not rectify, ended up tearing it off. I used the wet type application method, the decals I used are from the same place as yours (Andy at classic reproduction decals) which are good.

Any thoughts?
Mark
Hi Mark
Thanks, yeah the yellow number boards were a wee bit challenging!! I also used the wet method to put them on. I had quite a few air bubbles too but manage to squeeze most of them out. The ones I couldn't I burst with a needle. There was some tiny ones that didn't seem to want to bust but they seem to have gone now after its all painted.

I'm going to try and pop in to see performance 1 coatings later in the year about coating the exhausts as they are just round the corner form my Granny and planning a visit later in the year

Re: My KR1s Project

Posted: Fri Feb 19, 2016 4:55 pm
by Llewe
Hi Toby,

Thanks for the advice on the decals, I have ordered new ones and will have another go, but Bernie mentioned painting instead so I will take that route if my next attempt fails.

Cheers
Mark