Final KR Based Race Bike Project

[boggy]

Fantastic work Ben,your bike should fly when finished!

Rich =D> =D>

[500bernie]

Hi Ben,
Looking good =D>

[jarno]

can't wait fot the next photo's ben =D> =D>

[Luders]

Here's the airbox plug out of the bike. I'll be creating the mould this week and should have it complete by Thursday, for the next updat of the thread.

[Luders]

Just given the plug a clean and de-grease ready to apply the release agent and thought I would add another pic from the other side showing the cut out for the rear shock gas can.

[fred]

tidy work ben =D> ,i was just wondering what the lower cutouts for ?

[maccas]

Hi Ben,

Awesome work as usual!

I noticed you were thinking of using a twin pull throttle. Why not use a single pull then have an aftermarket splitter cable like from venhill.or similar? Will save you a bit of money on the throttle and will be a touch lighter weightwise too?

Dan

[Luders]

Do you mean the cut outs at the top of the airbox Fred? They are to clear the mounting points for the tail piece.

Not too sure about using a splitter cable. Why do the TZ's not use a splitter?

[maccas]

That is a good point, i don't know why they don't use a splitter.

Dan

[fred]

Hi ben. looks like a cutout down on right hand side of where right carb would sit.could be just the shine on the photo

[Luders]

I'm not sure where you mean Fred. Save a copy of the pic, draw an arrow on where you mean and post it again.

[Luders]

Do you mean the previous photo? That is the recess to clear the engine number on the gearbox case.

[fred]

thats it ben, are you going to the trackday weekend at cadwell in august ?

[Luders]

Yeah I would like to go

[tescr500]

Hi Ben good job look forward to see on the mean Kawasaki machine =D> =D> =D>