Now then guys, I ordered bearings from the bay, they are the wrong size.
Pretty hacked off but buy cheap, pay double, or more....
Where did you lot get them from? And did they come with the dust seals?
Cheers Martin.
Wheel bearings.....
-
- Heavy Smoker
- Posts: 199
- Joined: Wed Dec 16, 2009 9:41 pm
- Location: Shetland
-
- Oil Injector
- Posts: 706
- Joined: Sun Sep 30, 2007 5:59 pm
Re: Wheel bearings.....
beleive you want 6203 2RS, it's the same for both wheels, apart from the sprocket carrier. the 2RS will give you the Rubber Seals you want.
Try these
http://simplybearings.co.uk/shop/advanc ... 1a&x=0&y=0
Try these
http://simplybearings.co.uk/shop/advanc ... 1a&x=0&y=0
-
- Heavy Smoker
- Posts: 199
- Joined: Wed Dec 16, 2009 9:41 pm
- Location: Shetland
Re: Wheel bearings.....
Thank you very much.
It's a minefield the ebay, too many halfwits in the world.
This kr is turning into perhaps too much of a restoration. Haha!
Cheers!
It's a minefield the ebay, too many halfwits in the world.
This kr is turning into perhaps too much of a restoration. Haha!
Cheers!
-
- Avgas Sniffer
- Posts: 2120
- Joined: Sat Jun 09, 2007 10:10 am
- Location: Pig on the wall country
Re: Wheel bearings.....
SKF brand is a good make
Put bearings in the freezer still wrapped for a few hours before you fit them
Put bearings in the freezer still wrapped for a few hours before you fit them
Can it yer old boiler
- 500bernie
- Avgas Sniffer
- Posts: 3396
- Joined: Mon Aug 02, 2010 10:22 am
- Location: Teesside
Re: Wheel bearings.....
And heat the housing up with a hair drier, then they just drop in placeheadcoats wrote:SKF brand is a good make
Put bearings in the freezer still wrapped for a few hours before you fit them
Firecracker Red and Grey C3 300