KR1S Bearing Tube
-
- Avgas Sniffer
- Posts: 2120
- Joined: Sat Jun 09, 2007 10:10 am
- Location: Pig on the wall country
KR1S Bearing Tube
Like a Fog Bound Pinhead after taking the bearings out the wheels and forgetting about them for months,i don't know which bearing tube is which and I think there is an rgv front one in for good measure
So does anyone know if the front and back spacer tubes are the same width ? and does anyone know the widths
So does anyone know if the front and back spacer tubes are the same width ? and does anyone know the widths
Can it yer old boiler
-
- Oil Injector
- Posts: 872
- Joined: Mon Sep 07, 2009 8:33 pm
- Location: east yorkshire
There are some pictures in this thread here:
viewtopic.php?t=7116&highlight=wheel+bearing+spacer
No measurements though I'm afraid!
Dan
viewtopic.php?t=7116&highlight=wheel+bearing+spacer
No measurements though I'm afraid!
Dan
-
- Oil Injector
- Posts: 872
- Joined: Mon Sep 07, 2009 8:33 pm
- Location: east yorkshire
- Howie
- Avgas Sniffer
- Posts: 2055
- Joined: Mon Mar 16, 2009 9:33 pm
- Location: East Yorkshire
-
- Avgas Sniffer
- Posts: 2120
- Joined: Sat Jun 09, 2007 10:10 am
- Location: Pig on the wall country
Thanks all
Not going too well as it looks like the powdercoaters have blasted the bearing area a bit much on front right and now bearing can be pushed in by hand
Going to try bearing lock but also read up that going around bearing face area with a centre punch to nip the surface up
Not going too well as it looks like the powdercoaters have blasted the bearing area a bit much on front right and now bearing can be pushed in by hand
Going to try bearing lock but also read up that going around bearing face area with a centre punch to nip the surface up
Can it yer old boiler
- daz680
- Oil Injector
- Posts: 505
- Joined: Mon May 02, 2011 6:34 pm
- Location: Nuneaton, Warwickshire
- daz680
- Oil Injector
- Posts: 505
- Joined: Mon May 02, 2011 6:34 pm
- Location: Nuneaton, Warwickshire
-
- Avgas Sniffer
- Posts: 2120
- Joined: Sat Jun 09, 2007 10:10 am
- Location: Pig on the wall country
Re: KR1S Bearing Tube
Well sorted the tubes and got the bearings in
The loose bearing has been loctited in with stud and bearing lock,it says on the packet it is for worn bearing housings so fingers crossed.I put a blob of red paint on so will know if it spins in action
Plan B will be a 16mm wide bearing and 4mm off the wheel spacer but the bearing is a double row bearing so would that be o.k. for a wheel bearing ?
None of it is ideal but needs must and all that
The loose bearing has been loctited in with stud and bearing lock,it says on the packet it is for worn bearing housings so fingers crossed.I put a blob of red paint on so will know if it spins in action
Plan B will be a 16mm wide bearing and 4mm off the wheel spacer but the bearing is a double row bearing so would that be o.k. for a wheel bearing ?
None of it is ideal but needs must and all that
Can it yer old boiler