I'm after some swingarm bobbins for the paddock stand.
what size are the bolt holes and what is a good make/style to fit?
Which KR1S swingarm bobbins
-
- Avgas Sniffer
- Posts: 2120
- Joined: Sat Jun 09, 2007 10:10 am
- Location: Pig on the wall country
Which KR1S swingarm bobbins
Can it yer old boiler
-
- Avgas Sniffer
- Posts: 2120
- Joined: Sat Jun 09, 2007 10:10 am
- Location: Pig on the wall country
-
- Heavy Smoker
- Posts: 416
- Joined: Tue Jan 30, 2007 9:18 am
- Location: Melbourne AUS
Not sure on the exact pitch , but its very fine . Just get a set from a Kwak dealer as the thread is the same as most Kwacks , well ZX9 and ZX7 . Take your bike down to the shop and try em out .
As for the design , they all work the same just get a colour you like , a bolt on its own works fine but looks shit .
As for the design , they all work the same just get a colour you like , a bolt on its own works fine but looks shit .
- the-elf
- Avgas Sniffer
- Posts: 2800
- Joined: Wed Jul 26, 2006 2:48 pm
- Location: Rockingham, Western Australia
Don't know what the thread is on the factory one's which big K actually got round to tapping out. Most left the factory missing the threads in there and have since been tapped out by peeps wanting to fit there own bobbins. See if yoyu can borrow a thread gauge of someone and check the pitch. I bought one the other week of evil bay for a fiver.
-- Lets go Racing
Sponsored by:
Paddockstand Ltd: Tyre and Bike spares http://www.paddockstand.co.uk
Sponsored by:
Paddockstand Ltd: Tyre and Bike spares http://www.paddockstand.co.uk
-
- Avgas Sniffer
- Posts: 2120
- Joined: Sat Jun 09, 2007 10:10 am
- Location: Pig on the wall country
Cheers ears
I found these on flea bay
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... :IT&ih=013
Update
Got these and they fit the KR1S bobbin threads
The only thing is the bobbins are slightly different to each other
(see pic)
Question is does one have to fit on one side to make more clearance
for the stand etc
I found these on flea bay
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... :IT&ih=013
Update
Got these and they fit the KR1S bobbin threads
The only thing is the bobbins are slightly different to each other
(see pic)
Question is does one have to fit on one side to make more clearance
for the stand etc
Can it yer old boiler