Busted bulbs

pablo · Post by **pablo** » Fri Mar 12, 2010 8:11 pm

Does anyone know how I can stop my Husqvarna WR250 enduro busting stop and tail light bulbs

It's not blowing them,it's not the regulator,It must be vibration.Can't seem to finish a ride with an intact bulb

THE FLUTE · Post by **THE FLUTE** » Fri Mar 12, 2010 8:49 pm

My ktm does the same there is an american company that make LED ones for the ktm I will see if I can find it and let you know. Is yours AC or DC voltage??

mr_bungholeo · Post by **mr_bungholeo** » Fri Mar 12, 2010 8:55 pm

renew the rubbers on the bolts if it a few years old or fit h**da bulbs,they have a bridge between the filament to stop it vibrating to bits...

twostrokesmoker · Post by **twostrokesmoker** » Fri Mar 12, 2010 10:29 pm

Err push it everywere

Bert · Post by **Bert** » Sat Mar 13, 2010 4:03 pm

These guys will probably have a replacement LED to fit

http://www.customdynamics.com/

Bert

pablo · Post by **pablo** » Sat Mar 13, 2010 7:16 pm

THE FLUTE wrote: Is yours AC or DC voltage??

It's DC.I reckon LED looks like the way to go.The're expensive but at the rate I'm getting through bulbs it'll be worth it.