Spacers

garye345 · Post by **garye345** » Mon Jun 29, 2009 10:18 pm

Alright fella's
Thought i would post on here about this one.I am after some spacers to fit a R6 shock to my track bike.Thing is,i have never had owt like this made up before,so i am after a bit of advice.
This is what i am after

Two spacers needed,as the fzr shock is 10mm wider than the R6.It uses a 12mm bolt as opposed to a 10mm.
The green section needs to be 5mm wide,diameter doesn't really matter,anywhere between 14-20mm.The red section should be just under 12mm diameter and 7mm long.
Where would the best place to get some from,or better still,can anyone on here make them?

garye345 · Post by **garye345** » Sun Jul 05, 2009 4:15 pm

No one

Does anyone's mate dave,know where to get stuff like this done?
Cheers

JanBros · Post by **JanBros** » Sun Jul 05, 2009 4:42 pm

I can make them for you, if no one in the UK has a lathe

garye345 · Post by **garye345** » Sun Jul 05, 2009 9:58 pm

PM me a price Jan,would,nt think the postage should be that much,then again to send over 5kilo to you,was a small fortune

.
If you could sort it out Jan i would be most grateful,cheers =D>

JanBros · Post by **JanBros** » Mon Jul 06, 2009 10:29 pm

price ? will be cheap . not much work and almost no material.

can you send me the exact inner diameter off the bush in the shock. and do you want it to be a tight or loose fit ?

DAMO666 · Post by **DAMO666** » Tue Jul 07, 2009 6:52 am

Try this guy ,
http://cgi.ebay.co.uk/STAINLESS-STEEL-W ... 7C294%3A50

THE FLUTE · Post by **THE FLUTE** » Wed Jul 15, 2009 4:12 pm

All made mate just need an address!

mmmmmmmmmm titanium

garye345 · Post by **garye345** » Thu Jul 16, 2009 3:16 pm

THE FLUTE wrote:All made mate just need an address! mmmmmmmmmm titanium

Jolly good show old chap

If there made out of the old TI of TANIUM,i won't want to fit them,i will just be sitting there feeling um,mmmmmm and weighing them

THE FLUTE my friend,your a STAR

Thanks very muchly =D>